Cleaning And Storage; Motor Base - Tribest dynablend clean Manual De Uso

CLEANING AND STORAGE

1. After use, fill the Glass Pitcher
Buttons to remove most of food debris remaining on the Glass Pitcher.
NOTE: If necessary, you may add a couple drops of dish soap.
2. Empty the Glass Pitcher.
3. Repeat Step 1 and Step 2 with the Glass Pitcher
to rinse the pitcher thoroughly.
4. Empty the Glass Pitcher.
5. Dry the Glass Pitcher fully for the next use.
NOTE: If any food debris remains at the blade assembly area, remove the Stainless Steel
Blade Assembly using the Blade Opener provided to clean out the debris. (Please see
"How to Remove Blade Assembly from the Glass Pitcher" page 15.)

Motor Base

1. Unplug the power cord.
2. Wipe outside surface with a damp cloth or sponge. Do not use abrasive cleaners on
the Motor Base.
3. Dry with a soft cloth or paper towel.
4. The rubber feet on the bottom of the Motor Base will keep the blender in place on
most work surfaces. Clean the rubber feet regularly. When the rubber feet are dirty,
the machine may move on the counter.
WARNING:
How to Clean the White Silicone Seal
When you take out the Blade Assembly, you will see a white Silicone Seal placed on
the inside ridge of the Glass Pitcher. Wash the Silicone Seal with mild dish soap and
water. Wipe the Silicone Seal with a dry towel, then refer to the "How to Reassemble the
Stainless Steel Blade Assembly" on page 15.
14
Do not immerse the Motor Base in water.
1
/ full with clean water and run one of the Pre-Programmed
3
2
/
3
full of clean warm water with NO SOAP