COFFEE DISPENSING
Make sure that the start-up/stand-by button is on with the steady
green light.
Only compatible capsules may be inserted in the capsule holder draw.
Do not insert fingers or other objects.
Single-dose capsules are prepared to dispense one coffee/product.
DO NOT use the capsules more than once. Inserting two or more cap-
sules can cause the machine to malfunction.
To always have a coffee at the perfect temperature, it is recommended
to preheat the cup with hot water. Position the cup under the dispens-
ing spout without inserting the capsule. Turn the coffee dial to the
dispensing position to provide enough hot water to preheat the cup.
The first time you use the coffee machine, run a water supply only
(without capsule), before starting a coffee supply.
Place the cup under the coffee dispenser for a classic espresso.
1
Remove the drip tray to use cups of different sizes for a long coffee.
2
If, during the dispensing cycle power supply is interrupted or
water is exhausted within the tank proceed as follows:
- Turn the coffee dial to the stop position.
- Restore the power supply or fill the water tank up to the indicated
MAX level.
PREPARING THE COFFEE
- Press the start-up/stand-by button; wait for the steady green light
to be on.
- Replace the capsule inside the capsule holder drawer with a new one.
- Restart the coffee dispensing.
Remove the capsule holder drawer, insert a capsule and insert the
3
drawer again.
Turn the coffee to the dispensing position and wait for the desired
4
quantity to be provided.
Turn the coffee dial to the stop position.
5
The coffee automatically stops dispensing after 110 seconds.
Wait until the start-up/stand-by button is on with steady green light
before removing the capsule holder drawer.
Pull out the capsule holder drawer, remove the used capsule and insert
6
the drawer again with a new capsule. The machine is ready to dispense
a new coffee.
E N