Troubleshooting; Technical Specifications - LAVAZZA amodo mio Instrucciones De Uso

I T EN
Problem encountered
Machine does not turn on.
Power light is off after having
pressed the start-up/stand-by button.
The machine requires a lot of time to
heat up.
The machine is very noisy.
Red flashing light .
The coffee flows out too fast and no
creamy froth forms on the surface.
No coffee flows out or it just drips out
slowly.
No coffee flows out and the drip tray fills
with water.
The button of the cappuccino maker
flashes green accompanied by three
beeps.
• Nominal Voltage - Power Rating - Power Supply:
See label on the appliance
• Measurements: Height
253 mm
• Weight: approx. 4,2 kg
• Water tank: 0.5 L - Removable type

TROUBLESHOOTING

Possible causes
» Machine is not connected to the power
source.
» The machine has limescale build-up.
» No water in the tank.
» Water tank fitted incorrectly or
absent.
» Coffee dial in wrong position.
» Capsule already used.
» Dispensing spout is clogged.
» Coffee dial in wrong position.
» Malfunction of the cappuccino maker

TECHNICAL SPECIFICATIONS

Width Depth
272 mm 291 mm
Solution
» Connected the machine to the power source.
» Contact customer service.
» Descale the machine.
» Top up the tank with fresh drinking water.
» Fit the water tank correctly.
» Turn the coffee dial to the stop position.
» Contact customer servicea.
» Replace the capsule inside the capsule holder drawer
with a new one.
» Clean the coffee dispensing spout
(see MAINTENANCE AND CLEANING).
» Turn the coffee dial to supply position.
» Contact customer service.
• Housing materials: Thermoplastic
• Cable Length: 0.8 m
• Thermo fuses
• Instantaneous aluminum boiler with temperature probe