Monthly Maintenance - Tennant V5 Manual Del Operador

Tennant V5

Monthly Maintenance:

* Check the brush strips on the fl oor tool – if brushstrips
are worn out, fl oortool should be exchanged.
* Check the cartridge fi lter - should it be cleaned or
replaced.
Annual Check Up:
* Clean the cable and inspect for damaged
insulation.
* Clean and lubricate the wheels and castors.
* Check all machine functions.
GB.7.2 Replacement of Filters
Please use only original Tennant fi lters and take note of
the instructions on the fi lter or fi lter pack!
Spare filters can be purchased from your Tennant
distributor. Please note that only genuine Tennant
filters are guaranteed to give a constant high filter
performance.
GB.7.2.1 Paper Filter Bag
Please take note of the information printed on each
genuine Tennant paper fi lter bag - it will assist you
when changing the bag.
Firstly, hold the rubber cuff of the suction pipe
coupling, rotate this anti-clockwise and remove the
coupling from the tank connector.
Hold onto the tab of the fi lter bag trap door and gently
pull upwards. This will automatically close the trap door
(preventing any dust from escaping) and the bag will
slide upwards and out of the tank.
6
The new paper fi lter bag may now be installed. Simply
locate the cardboard edges of the paper bag mounting
plate into the locating grooves in the tank and slide the
bag down into position.
The suction hose coupling may now be reinserted into
the tank socket - hold the rubber cuff, insert the coupling
and lock into position by rotating clockwise
GB.7.2.2 Micro Filter
The micro fi lter is secured in position below the motor
by means of a simple press fi tting. Two recesses, in the
mounting column, above the cartridge fi lter, on the left
and right sides, allow you to insert the middle fi ngers of
both the left and right hands and gently pull upwards on
the underside of the cartridge fi lter. To replace the new
or cleaned cartridge simply push it gently downwards
onto the mounting column.