Menu Structure; Basic Instructions - Dal Zotto Edy Manual Del Usuario

menu sTrucTure

To access the menu, keep key 5 pressed for a few seconds.
seT clock
*
enable chrono
3
seT chrono
3
lanGuaGe
3
user
* Where present – certain models.
When "ENABLE CHRONO" is not included in the menu, enabling is done directly in SET CHRONO.

basic insTrucTions

The following recommendations must be followed the first times the
stove is ignited:
Š it is possible that slight odours are produced due to the drying
of the paints and silicones used. Do not remain in the environment
for long periods.
Š Do not touch the surfaces as they could still be unstable.
Š air the room well several times.
Š The hardening of the surfaces is terminated after several
heating processes.
Š This appliance must not be used to burn waste.
Do noT use any inflammable liQuiDs for iGniTion!
Do noT alloW The baG of pelleTs To come inTo conTacT WiTh The boilinG hoT sToVe DurinG The fillinG phase!
in The eVenT of conTinuous no iGniTion, conTacT an auThoriseD Technician.
iT is forbiDDen To use The appliance WiThouT The DiViDer anD/or
Glass proTecTion (see fiGure aT The siTe) jeoparDises The safeTy of
The proDucT anD leaDs To The immeDiaTe VoiDinG of The WarranTy
perioD. in The case of Wear or DeTerioraTion reQuesT afTer-sales
assisTance for replacemenT of The parT (replacemenT ThaT is noT
unDer GuaranTee as The componenT is subjecT To Wear).
36
5
enable chrono
5
prOg. 1 - 2 - 3 - 4
ON/OFF
5
iT,en,fr,De,es
5
2 - 3
5 pelleT
5
sTanD by
5
reseT
sTarT proG 1
5
CONFirm
sTop proG 1
wiTh Key 1
5
monD - friD
2 - 3
5
sTarT proG 2
2 - 3
5
sTop proG 2
2 - 3
5
monD - friD
Before igniting the stove, the following points must be verified:
Š the feed-box must be full of pellets.
Š the combustion chamber must be clean.
Š The burn pot must be completely free and clean.
Š check the hermetic closure of the fire door and the ash drawer.
Š make sure the power supply cable is connected correctly.
Š the bipolar switch in the rear right part must be positioned on
1.
ENGLISH
Key 1 to confirm parameter/
programming and exit.
Keys 2 and 3 to set data/parameters.
Keys 4 and 5 to go forward or backward
in the menu.
5
5
2 - 3
5
2 - 3
5
2 - 3
5
2 - 3
2 - 3
2 - 3
Day
2 - 3
hour
2 - 3
minuTes
2 - 3
Day
2 - 3
monTh
2 - 3
year
2 - 3