Reset; Comfort; Enable Chrono; Chrono - Dal Zotto Edy Manual Del Usuario

reseT

allows all values that can be modified by the user to be reset to the default values. The modified data is the following:
CONTrOls prOCeDUre
press key 5 until seT clock appears.
Š
press key 3 several times until user appears.
Š
press key 5.
Š
press key 5 until "reseT" appears.
Š
Use keys 2-3 to select on and press key 5.
Š
"Done" will appear on the display to confirm.
Š

comforT

(in certain models)
This mode reduces the fan speed, making the stove quieter.
CONTrOls prOCeDUre
To activate, press key 4 until comforT on appears on the display.
Š
To de.activate, press key 4 until comforT off appears on the display.
Š
When The comforT moDe is acTiVe The leD for fan 1 Will flash on The conTrol panel.
When The comforT funcTion is acTiVaTeD usinG key 4, The sToVe Will alWays operaTeD aT reDuceD fan
speeD!

enable chrono

it allows to enable/disable the chrono and the various time slots. when enabling the time slots, besides activating (ON) and de-activating
(OFF), it is also possible to select the COmFOrT function for selected time slots.
CONTrOls prOCeDUre
Š press key 5 for a few seconds, until seT clock appears.
Š press key 3 several times to reach enable chrono.
Š press key 5, to confirm and use keys 2-3 to enable "on" or disable "off" the chrono.
Š Use keys 4 -5 to select the desired time slot.
Š press keys 2 - 3 to enable "on" or disable "off" the comforT mode for the selected time slot.
Š press key 1 several times to confirm and exit the menu.

chrono

The chrono allows to program 2 time spans within a day to use every day of the week.
The switch-on and switch-off time can be set in every time slot, along with the days of use of
the programmed time slot.
reCOmmeNDaTiONs
The ignition and switch-off times must be within the arc of one day,
from 0 to 24 and not over several days:
Before using the chrono function, set the current day and time.
Therefore check that the points listed in the "Set clock" sub-chapter
have been followed, so that the chrono function works. aside from
programming it, it must also be activated.
switch-on time 07:00
switch-off time 18:00
switch-on time 22:00
switch-off time 05:00
ENGLISH
example:
correcT
incorrecT
41