Operating State - Soler & Palau ADVANZ Instrucciones De Uso



Selecting an item in the menu
- turn the knob until you select the desired item, which will be displayed with bright writing on a dark
background
- press the number to confirm your selection: the new window will be displayed.
Returning to the synoptic window
The synoptic window is accessed from the Menu window by following the change window procedure.
O
PERATING STATE
If the control is used to operate several units (master-slave mode), a screen will be displayed in the menu
with the list of available units (max. 4):
Unit1
Unit2
...
Unit4
The unit whose state is to be monitored must be selected: turn the knob until the desired unit is
highlighted, then press the knob.
If the control is configured for one unit, the state of the unit is shown directly by displaying the values of
the parameters that characterize the unit:
Installer;
Factory (protected password, accessible only from factory).