Installation - Miele professional XKM 3000 L Med Instrucciones De Montaje

Installation

 Before installing the communication module compare the con-
nection data (voltage and frequency) on the data plate with that on
the data plate of your washer-disinfector. If the data does not
match, the module could sustain damage. If in any doubt, consult
an electrician.
Disconnect the washer-disinfector from the mains electricity supply.

Remove any stickers or protective caps as necessary from the slot

aperture.
Push the module into the module slot. Gently push the module until

it clicks into place.
Establish a cable connection between the module and your terminal

device.
Make sure that the cable is laid correctly and that it is not kinked or
trapped anywhere. It must be protected from sharp edges and not
subjected to tension.
Only use terminal devices (PC, printers etc.) which comply with EN/
IEC 60950.
Connect the washer-disinfector to the electrical supply.

The module is supplied with electricity via the washer-disinfector.
An additional electrical connection is not necessary.
en - Fitting and installation
41