Intended Use; Technical Data - EINHELL TE-ID 650E Manual De Instrucciones

Anleitung TE_ID_650_E_SPK8__ 11.09.12 15:33 Seite 17

4. Intended use

The drill is designed for drilling holes into wood, iron,
non-ferrous metals and rock using the appropriate
bits.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user/operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.

5. Technical data

Mains voltage:
Power input:
Idling speed:
Drilling capacity:
Protection class:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745-1 and EN 60745-2-1.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Hammer drilling in concrete (handle)
Vibration emission value a
h,ID
2
K uncertainty = 1.5 m/s
Hammer drilling in concrete (additional handle)
Vibration emission value a
K uncertainty = 1.5 m/s
Drilling in metal (handle)
Vibration emission value a
K uncertainty = 1.5 m/s
Drilling in metal (additional handle)
Vibration emission value a
K uncertainty = 1.5 m/s
The specified vibration value can be used to compare
the equipment with another electric power tool.
Important.
The vibration value may change depending on how
the electric equipment is used and may exceed the
specified value in exceptional circumstances.
Warning! The electric power tool generates an
230 V ~ 50 Hz
electromagnetic field during operation. Under certain
650 W circumstances this field may actively or passively
impede medical implants. To reduce the risk of
-1
0-3,000 min
serious or fatal injuries, we recommend persons with
Concrete 13 mm
medical implants to consult their doctor and the
Steel 10 mm manufacturer of the medical implant prior to using the
equipment.
Wood 25 mm
II /
Residual risks
Even if you use this electric power tool in
2.2 kg
accordance to instructions, certain residual risks
cannot be eliminated. The following hazards may
arise in connection with the equipment's
construction and layout:
1. Lung damage, if no suitable protective dust mask
2. Damage to hearing, if no suitable ear protection is
93.3 dB(A)
3 dB
3. Health damage caused by hand-arm vibrations, if
104.3 dB(A)
3 dB
The specified vibration value can be used to
recognize a prospective impairment of the
equipment's performance.
Reduce noise generation and vibration to a
minimum!
n
2
= 16.306 m/s
n
n
n
n
= 12.345 m/s
h,ID
2
= 5.848 m/s
h,D
2
= 1.818 m/s
h,D
2
is applied.
applied.
the equipment is used over a longer period or is
not properly guided and maintained.
Vibration levels higher than 2.5 m/s
damage to the joints in your hand and arm.
Use only equipment that is in perfect condition.
Maintain and clean the equipment regularly.
Adopt your way of working to the equipment.
Do not overload the equipment.
GB
2
2
2
2
may cause
17