Onkyo CR-N775D Serie Manual De Instrucciones página 11

> Before Start > Part Names
Initial Setup
Would you like to start Wi-Fi setup?
Yes
No
To make Wi-Fi settings, select "Yes". Select the method
for setting in the next screen (for example "Scan
Networks").
Wi-Fi Setup
Scan Networks
Use iOS Device
Input SSID
∫ Scan Networks
From the list of SSID for access points such as wireless
LAN routers, select the required SSID and make the
settings.
1. Select the SSID of the access point you want to
connect and then confirm.
Wi-Fi Setup
aaaaaaaaaaaaaaa
bbbbbbbbbbbbbbb
cccccccccccccccc
ddddddddddddddd
2. Select either "Enter Password" or "Push Button" and
confirm. If the access point has an automatic setting
> Install
button, by selecting "Push Button" you can connect
without entering a password.
3. If you select "Enter Password", enter the password
of the access point. For details on how to enter text,
refer to "Entering text" (
Asb
If you select "Push Button", then after pressing and
holding the automatic setting button on the access
point for the required amount of time, press ENTER
on the remote controller.
4. is displayed when the settings are complete.
Asb
∫ Use iOS Device
Set by sharing the iOS device's Wi-Fi settings with this
unit.
1. Connect the iOS device by Wi-Fi.
2. Select this unit in the "SET UP NEW AIRPLAY
SPEAKER..." item in the Wi-Fi setting screen of the
iOS device, then select "Next".
> Initial Setup > Playback
Asb
Wi-Fi Setup
Enter Password
Push Button
P36).
Password
A/a OK
MEMORY Hide/Show
Supplementary information | Advanced Setup | Others
0 This unit is displayed as "Onkyo CR-N775D
XXXXXX".
3. After establishing the connection, select "Done" on
the screen of the iOS device.
4. is displayed when the settings are complete.
∫ Enter SSID of the access point
Set by entering the SSID of the access point you want
to connect.
1. Enter the SSID. For details on how to enter text,
refer to "Entering text" ( P36).
SSID
A/a OK
2. Select and confirm the authentication method.
Asb
Security Method
None
WEP
WPA
WPA2
0 If you select "None", proceed to step 3. If you
select "WEP", "WPA", or "WPA2", enter the
password and confirm.
3. is displayed when the settings are complete.
11
En