Cutting Attachment; Special Accessories - Stihl MS 260 Manual De Instrucciones

English / USA

Cutting Attachment

Recommended cutting attachments
for compliance with § 5.11 of ANSI
standard B 175.1-2000
(see page 14 of this manual):
STIHL reduced kickback bar
(with green label) for 0.325" and 3/8"
pitch:
Rollomatic with sprocket nose
16, 18 or 20" (40, 45 or 50 cm)
1)
STIHL low kickback chain
(with green label) for 3/8" pitch:
0.325" (8.25 mm) Rapid-Micro 2
(26 RM 2)
3/8" (9.32 mm) Rapid-Micro 2
(33 RM 2, 36 RM 2)
Chain sprocket:
7-tooth for 0.325" pitch
7-tooth for 3/8" pitch
1)
See definition of "low kickback
chain" on page 17 of this manual.
64
In order to comply with the kickback
performance requirements of § 5.11 of
ANSI standard B 175.1-2000, do not use
replacement saw chain unless it has
been designated as meeting the ANSI
§ 5.11 requirements on this specific
powerhead, or has been designated as
1)
"low kickback" saw chain
accordance with the ANSI B 175.1-2000
standard.
Since new bar/chain combinations may
be developed after publication of this
manual, ask your STIHL dealer for the
latest recommendations.
Other bars and chains available for this
powerhead are:
STIHL yellow-labeled guide bars:
For 0.325" and 3/8" pitch:
Rollomatic "S" with sprocket nose
16, 18 or 20" (40, 45 or 50 cm )
60 cm (24") for 3/8" pitch only
Duromatic with stellite tipped nose
16, 18 or 20" (40, 45 or 50 cm)
60 cm (24") for 3/8" pitch only
STIHL yellow-labeled chains:
For 0.325" pitch:
Rapid-Micro (26 RM)
Rapid-Super (26 RS)
For 3/8" pitch:
Rapid-Micro (33 RM, 36 RM),
Rapid-Super (33 RS, 36 RS)
1)
See definition of "low kickback
chain" on page 17 of this manual.

Special Accessories

Contact your STIHL dealer for
information regarding special
accessories that may be available for
your product.
in
MS 260