Switching The Auxiliary Setting; Setting The Rear Output And Subwoofer Controller - Pioneer DEH-4150SD Manual De Instrucciones

Section
Initial Settings
04
2 Press MULTI-CONTROL to display the
setting mode.
3 Turn MULTI-CONTROL to select the AM
tuning step.
Turning MULTI-CONTROL will switch the AM
tuning step between 9 kHz and 10 kHz. The se-
lected AM tuning step will appear in the dis-
play.
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
4 Press MULTI-CONTROL to determine
the selection.
# Even if the menu has been cancelled before
determination, operation is settled.

Switching the auxiliary setting

It is possible to use auxiliary device with this
unit. Activate the auxiliary setting when using
auxiliary device connected to this unit.
1 Use MULTI-CONTROL to select AUX in
the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to turn AUX on.
# To turn AUX off, press MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit's rear output (rear speaker lead out-
put and RCA rear output) can be used for full-
range speaker (REAR SP :FULL/
PREOUT :REAR) or subwoofer
(REAR SP :SUB W/PREOUT :SUB W) connec-
tion. If you switch the rear output setting to
REAR SP :SUB W, you can connect a rear
speaker lead directly to a subwoofer without
using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (REAR SP :FULL). When rear
26
En
Black plate (26,1)
output is connected to full range speakers
(when REAR SP :FULL is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controller's (low pass filter,
phase) built-in PREOUT :SUB W or the auxili-
ary PREOUT :REAR.
1 Use MULTI-CONTROL to select
SW CONTROL in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to display the
setting mode.
# Press DISP/BACK/SCRL to return to the pre-
vious display.
3 Use MULTI-CONTROL to select the de-
sired setting.
Press to switch the segment you wish to set
between left and right. Turn to change the set-
ting of each segment.
Left segment Right segment
FULL (full-range speaker)
REAR SP
(rear speaker setting)
SUB W (subwoofer)
SUB W (subwoofer)
PREOUT
(RCA output setting)
REAR (full-range speaker)
# When you select REAR SP :SUB W, you can
not set PREOUT (RCA output setting).
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
23).
! If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
YRD5269-A/S
< >26