Mtg D, Mtw D, Mhp D - General; Up/Down Function; Jobmaster Function - Fronius MTG 250d Manual De Instrucciones

MTG d, MTW d, MHP d - General

Up/Down function

JobMaster func-
IMPORTANT!
tion
Coded messages can appear on the JobMaster.
These correspond to the service code displayed on the control panel at the same time (see
the "Troubleshooting" section of the power source operating instructions).
SynchroPulse (option) - no symbol lights up on the JobMaster (see the "MIG/MAG weld-
ing" section of the power source operating instructions).
1
1
- Select one of the following parameters
on the power source:
- Wire feed speed
- Job number
- Set the parameters using the Up/Down
function
IMPORTANT!
In the "MIG/MAG Standard Synergic and
Pulse Synergic Welding" operating mo-
des, extra parameters can be set.
2
2
41