Connecting Cables; Digital Connection - Eizo FlexScan SX2461W Manual Del Usuario

Prior to use

Connecting Cables

Attention
• When replacing the current monitor with a SX2461W/SX2761W monitor, be sure to change the PC
settings for resolution and vertical frequency to those which are available for the SX2461W/SX2761W
monitor referring to the resolution table (back of cover page) before connecting the PC.
NOTE
• When connecting two PCs to the monitor, refer to the User's Manual on the EIZO LCD Utility Disk (CD-ROM).
1
Check that the monitor and the PC are powered off.
2
Connect the monitor to the PC with a signal cable that matches the connectors.
After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.
Connectors on
the PC
DVI connector
USB Downstream
Connectors on
the PC
D-Sub mini 15-pin
connector
USB Downstream
* Required when using the UniColor Pro software and the ScreenManager Pro for LCD software. (Refer to the
User's Manual on the UniColor Pro (CD-ROM) or the EIZO LCD Utility Disk (CD-ROM).)
3
Plug the power cord into a power outlet and the Power connector on the monitor.
Installation Setting/Adjustment

Digital connection

Signal cable FD-C39 (supplied)
EIZO USB cable MD-C93 (supplied)*
Analog connection
Signal cable FD-C16 (supplied)
EIZO USB cable MD-C93 (supplied)*
Troubleshooting
Connectors on
the monitor
DVI-I connector
USB Upstream
Connectors on
the monitor
DVI-I connector
USB Upstream
3