Filter Indicator; Care Index; Back Panel - Sharp KC-F32EU Manual De Instrucciones

CARE AND MAINTENANCE
CARE AND MAINTENANCE

FILTER INDICATOR

The filter Indicator Light will turn
on after approximately 720 hours.
(30 days × 24 hours =720 hours)
RESET This is a reminder to perform the
(Press 3 sec.)
maintenance described below.
(Ref.E-13,E-14,E-15,E-16)

CARE INDEX

Sensor
Filter
Unit
(Ref.E-16)

BACK PANEL

SENSOR
Sensor (internal)
Back Panel
SENSOR
Sensor Filter
KC-F32EU_OM_WEST.indb 13
In case of using at the location where air pollution and odour are
significant, maintain frequently even if Filter Indicator Light is not ON.
HEPA Filter (Ref.E-16)
Deodorizing Filter
(Ref.E-16)
Back Panel
Gently remove dust with an appropriate cleaning tool,
such as a vacuum cleaner with the proper attachment.
NOTE How to clean when overly dirty
BACK PANEL
1. Add a small amount of kitchen detergent to
• DO NOT apply excessive pressure when
2. Rinse off the kitchen detergent with clean water.
3. Completely dry the filter in a well-ventilated area.
1. Remove the Back Panel and removing
2. Gently remove dust from the Sensor with
3. If the Sensor Filter is overly dirty, wash it
E-11
E-13
After performing
maintenance, reset
the Filter Indicator.
Press more than 3 seconds.
water and soak for about 10 minutes.
CAUTION
CAUTION
scrubbing the back panel.
the Sensor Filter.
an appropriate cleaning tool, such as a
vacuum cleaner with the proper attachment.
with water and dry it thoroughly.
RESET
(Press 3 sec.)
Humidifying Filter
Filter Frame
Humidifying Tray
(Ref.E-14,E-15)
2017-09-28 08:58:21