Filter Indicator Light - Sharp FU-P60S-E Manual De Uso

SENTINEL Operation Indicator Light
When Plasmacluster Ion mode is ION AUTO or CLEAN mode, SENTINEL Operation is ready to be
activated, and when SENTINEL Operation is in active, the Plasmacluster Indicator Light (blue) turns on
and repeats its colour cycles between dark and light, and also the SENTINEL Operation Indicator Light
(green) turns on.
The "SENTINEL" function detects any air environment that is favourable for activation of mold, virus and
allergen using its 4 sensors for dust, odour, temperature and humidity, and it releases Plasmacluster
Ions to create an environment that controls the activity of airborne microbes.
The fan speed and amount of Plasmacluster Ions are automatically increased during AUTO operation,
while only the amount of Plasmacluster Ions is automatically increased during manual fan control mode
and Pollen mode.
PLASMACLUSTER INDICATOR LIGHT
Plasmacluster ion operation is selected using the remote control.
Blue light
When the Plasmacluster ion operation is in Clean Mode, or in AUTO Plasmacluster Ion Mode and the air
in the room is impure, the Plasmacluster ions will be released continuosly.
Green light
When the Plasmacluster ion operation is in the Ion Control Mode, or in AUTO Plasmacluster Ion Mode
and the air in the room is clean, this light will be activated and the unit will operate in Ion Control Mode.
Light off
There are no Plasmacluster ions being generated.
• The light can be turned off by using the 'LIGHTS ON/OFF Button' on the Remote Control. In this case,
Plasmacluster ions are generated.
(Please turn off the light when not required.)
CLEAN-SIGN LIGHT
The colour changes according to the air condition.
Clean (Green) Slightly Impure (Orange)
ABOUT THE CLEAN-SIGN
• The condition of the CLEAN-SIGN depends on the room air condition detected by the Dust and Odour
Sensor when the plug is inserted into the wall outlet.
• It is possible to have a green CLEAN-SIGN with impurities in the air at the time that the air purifier was
just introduced to the room environment. After a while, however, the base impurity rate will be adjusted
to detect room air condition correctly.
• Use the Lights ON/OFF Button on the remote control to turn off the Indicator light.
DETERMINING THE BASE IMPURITY RATE
For the first 30 seconds after the power plug is inserted into the wall outlet, the unit will check the condi-
tions of the air. If operation is set to ON during this time, the CLEAN-SIGN LIGHT will alternately flash in
green, orange and red.

FILTER INDICATOR LIGHT

Clean the Active Carbon Filter when the Filter Indicator Light is on.
(The indicator light will be activated in about 2 months, when using the unit for 24 hours a day.)
(See Page E-12)
Very Impure (Red)
E-9