Ignition System Maintenance; Maintaining The Electronic Crossover Ignition System - Weber SPIRIT E-210 GBS Manual De Instrucciones

MAINTAINING THE ELECTRONIC
CROSSOVER IGNITION SYSTEM
®
The igniter module supplies power to the electronic
Crossover ignition system and the side burner with
®
one igniter button. Whether you are performing routine
maintenance or a troubleshooting check on the ignition
system, read the following to keep your ignition system
working properly.
If the electronic Crossover ignition system fails to ignite,
®
you'll need to pinpoint where the problem is occurring:
with the gas flow or with the electronic ignition system.
Begin by attempting to match light your burners. Refer
to "MAIN BURNER IGNITION - Lighting with a Match."
If match lighting is successful, the problem lies in the
ignition system.
• Verify that the AA battery (alkaline only) is in good
condition and is installed correctly (1). Some batteries
have a plastic protective wrap around them. This
plastic must be removed before installing battery. Do
not confuse this plastic with the battery label.
• Make sure the igniter wires are properly attached to
the igniter module. Refer to the "IGNITER MODULE
WIRE CHART" chart on this page.
• Make sure the ceramic igniter assembly is fully
inserted into burner tube igniter channel (2). If
properly positioned, you will hear a snap (3).
• Make sure the electronic igniter button is working by
listening for clicking and looking for sparks at burner.
If the electronic Crossover ignition system still fails to
®
ignite, contact the Customer Service Representative in
your area using the contact information on our web site.
Log onto www.weber.com.
24
WWW.WEBER.COM
®

IGNITION SYSTEM MAINTENANCE

IGNITER MODULE WIRE CHART (E-210
4 3
BURNER 1
Black Terminal (1)
Yellow Terminal (2)
1
2 1
2
3
/ E-310 )
™ ™
2 1
3
4
IGNITER BUTTON
Black Terminal (3)
Black Terminal (4)