Storage; Guide Bar Maintenance; General Maintenance; Environmental Protection - Stiga CS 48 Li 14 Manual De Instrucciones

Ocultar thumbs Ver también para CS 48 Li 14:
Tabla de contenido

Publicidad

times, reset its level. Use a flat file.
Finally, round off the depth gauge.
NOTE: It is recommended to have
the deep or important
sharpening carried out by a service agent
who is equipped with electric sharpener.

GUIDE BAR MAINTENANCE

• When you have finished working,
clean out the groove and the oil
passages with a scraping hook.
• Periodically trim the sides of rails using a flat
file. If not done in the long run, the feather
edges might break away and damage the bar.
• If one rail is higher than the other
one, it is necessary to make it even
with a flat file then smooth it with a
file or fine grain abrasive paper.
When servicing, use only
identical replacement parts. Use of
any other parts may create a hazard
or cause product damage.
To avoid serious personal
injury, always remove the
battery pack from the tool when
cleaning or performing any
maintenance.

GENERAL MAINTENANCE

Before each use, inspect the entire product
for damaged, missing, or loose parts such
as screws, nuts, bolts, caps, etc. Tighten
securely all fasteners and caps and do
not operate this product until all missing
or damaged parts are replaced. Please
call Customer Service for assistance.
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to damage
from various types of commercial solvents
and may be damaged by their use. Use clean
cloths to remove dirt, dust, oil, grease, etc.
Do not at any time let brake
liquids, gasoline, petroleumbased
products, penetrating oils, etc.,
come in contact with plastic
parts. Chemicals can damage,
weaken or destroy plastic
which may result in serious personal injury.
Only the parts shown on the parts list are
intended to be repaired or replaced by
the customer. All other parts should be
replaced at an authorised service centre.

7. STORAGE

STORING THE PRODUCT
• Remove the battery pack from
the unit before storing.
• Clean all foreign material from the unit.
• Store it in a place that is
inaccessible to children.
• Keep away from corrosive agents such as
garden chemicals and de-icing salts.
• Store and charge your batteries in a cool area.
Temperatures above or below normal room
temperature will shorten battery pack life.
• Never store batteries in a discharged
condition. Store battery packs in a
30%-50% charged condition.
• Store the battery pack where the temperature
is below 27 FIC and away from moisture.
• All batteries gradually lose their charge. The
higher the temperature, the quicker they lose
their charge. If you store your unit for long
periods of time without using it, charge the
pack as normal every six months of storage.
This practice will prolong battery pack life.

ENVIRONMENTAL PROTECTION

1) Environmental protection should be a
priority of considerable importance when
using the machine, for the benefit of both
social coexistence and the environment
in which we live. Try not to cause any
disturbance to the surrounding area.
2) Scrupulously comply with local regulations
for the disposal of packaging, deteriorated parts
or any elements with a strong environmental
impact; this waste must not be disposed of
as normal waste, it must be separated and
taken to specified waste disposal centres
where the material will be recycled.
3) Scrupulously comply with local regulations for
the disposal of waste materials after mowing.
4) At the time of decommissioning, do not
pollute the environment with the machine,
but hand it over to a disposal centre, in
accordance with the local laws in force.
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cs 48 li 16

Tabla de contenido