Stihl BF-KM Manual De Instrucciones página 7

unauthorized attachments are useable
with STIHL power tools, their use may,
in fact, be extremely dangerous.
If this tool is subjected to unusually high
loads for which it was not designed (e.g.
heavy impact or a fall), always check
that it is in good condition before
continuing work. Check in particular that
the fuel system is tight and that the (no
leaks) and that the controls and safety
devices are working properly. Do not
continue operating this machine if it is
damaged. In case of doubt, have it
checked by your STIHL servicing dealer.
THE USE OF THE POWER TOOL
(KOMBIENGINE EQUIPPED WITH
SOIL CULTIVATOR KOMBITOOL)
Transporting the Power Tool
WARNING
To reduce the risk of injury from loss of
control and blade contact, never carry or
transport your power tool with the
working tool moving.
WARNING
Always switch off the engine and make
sure the working tool has stopped before
putting a power tool down.
BF-KM
It may be carried only in a horizontal
position. Grip the shaft in a manner that
the machine is balanced horizontally.
Keep the hot muffler away from your
body and the soil cultivating attachment
behind you.
WARNING
When transporting it in a vehicle,
properly secure it to prevent turnover,
fuel spillage and damage to the unit.
Before Starting
WARNING
Always check your power tool for proper
condition and operation before starting.
Never attempt to modify the controls or
safety devices.
WARNING
Never operate your power tool if it is
damaged, improperly adjusted or
maintained, or not completely or
securely assembled.
WARNING
Do not attach any soil cultivating
attachment to a unit without proper
installation of all required parts. Failure
to use the proper parts may cause the
blades to fly off and seriously injure the
operator or bystanders.
WARNING
The soil cultivating attachment must be
properly tightened and in safe operating
condition. Inspect for loose parts (nuts,
screws, etc.) and for cracked, bent,
warped or damaged blades. Replace
damaged blades before using the power
tool.
Keep the handles clean and dry at all
times; it is particularly important to keep
them free of moisture, pitch, oil, fuel mix,
grease or resin in order for you to
maintain a firm grip and properly control
your power tool.
Keep the deflector adjusted properly at
all times (see chapter "Assembling the
Unit" of your instruction manual).
Adjust harness and hand grip to suit
your size before starting work. To be
better prepared in case of an
emergency, practice releasing the unit
from the harness as quickly as possible.
Starting
WARNING
Start the engine at least 10 feet (3 m)
from the fueling spot, outdoors only.
For specific starting instructions, see the
appropriate section of your
KombiEngine and KombiTool manuals.
Place the power tool on firm ground or
other solid surface in an open area.
Maintain good balance and secure
footing.
English
5