JVC KW-R930BT Manual De Instrucciones página 16

BLUETOOTH®
To
While talking on the first incoming call...
Answer another incoming call
and hold the current call
Reject another incoming call
While having two active calls...
End current call and activate
held call
Swap between the current
call and held call
Adjust the phone volume * 1
[00] to [35] (Default: [15])
Switch between hands-free
and private talk modes *
2
*
1
This adjustment will not affect the volume of the other sources.
* 2
Operations may vary according to the connected Bluetooth device.
Improve the voice quality
While talking on the phone....
1 Press and hold .
2 Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
12
ENGLISH
On the faceplate
Press or the volume knob.
Press and hold or the volume
knob.
Press and hold or the volume
knob.
Press .
Turn the volume knob during a call.
Press during a call.
.
MIC GAIN LEVEL –10 to LEVEL +10 (LEVEL –04): The sensitivity of the
microphone increases as the number increased.
NR LEVEL LEVEL –05 to LEVEL +05 (LEVEL 00): Adjust the noise
reduction level until the least noise is being heard during a phone
conversation.
ECHO CANCEL LEVEL –05 to LEVEL +05 (LEVEL 00): Adjust the echo cancellation
delay time until the least echo is being heard during a phone
conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select an item (see the following
table), then press the knob.
3 2
Repeat step until the desired item is selected or activated.
To return to the previous setting item, press
SETTINGS
AUTO ANSWER 01 SEC to 30 SEC: The unit answers incoming call automatically in
the selected time (in seconds). ; OFF: Cancels.
RING COLOR COLOR 01 to COLOR 49 (COLOR 08): Selects the illumination color
for the buttons as notification when there is an incoming call and
during a call. ; OFF: Cancels.
BATT/SIGNAL *
AUTO: Shows the strength of the battery and signal when the unit
detects a Bluetooth device and the Bluetooth device is connected. ;
OFF: Cancels.
* Functionality depends on the type of the phone used.
Default: XX
.
Default: XX