Configuration - Nokia 6136 Manual Del Usuario

■ Enhancements
This menu is shown only if the phone is or has been connected to a compatible
mobile enhancement, other than the charger.
Select Menu > Settings
if the corresponding enhancement is or has been connected to the phone.
Depending on the enhancement, select from one of the following options:
Default profile — to select the profile that you want to be automatically activated
when you connect to the selected enhancement
Automatic answer
after five seconds. If
answer is off.
Lights — to set the lights permanently On. Select
for 15 seconds after a key press
Ignition detector >
20 seconds after you switch off the car ignition, when the phone is connected to
the full car kit
TTY/TDD > Use TTY

■ Configuration

You can configure your phone with settings that are required for certain services
to function correctly. The services are multimedia messaging, instant messaging,
synchronization, streaming, and browser. Your service provider may also send you
these settings as a configuration message.
To save the configuration settings received as a configuration message, see
"Configuration settings service," p. 9.
Select Menu > Settings
Default configuration settings
Scroll to a service provider, and select
configuration settings of this service provider supports. To set the configuration
settings of the service provider as default settings, select
To delete configuration settings, select Delete.
Activate default in all applications
settings for supported applications
Preferred access point
and select Options >
and packet data access point or GSM dial-up number.
> Enhancements. You can select an enhancement menu
— to set the phone to answer an incoming call automatically
Incoming call alert
On — to automatically switch off the phone approximately
> Yes — to use text phone settings instead of headset settings
> Configuration
— to view the service providers saved in the phone.
Details
— to activate the default configuration
— to view the saved access points. Scroll to an access point,
Details to view the name of the service provider, data bearer,
is set to Beep once
Automatic
and one of the following options:
to view the applications that the
Options
S e t t i n g s
or Off, automatic
to set the lights on
> Set as default.
51