Joie juva Manual De Instrucciones página 11

ii. Installing with Base
see images -
25 31
1. Unfold the load leg from
storage compartment.
2. After placing the base on the
vehicle seat, squeeze load leg
adjustment button to extend
the load leg to floor
26
the load leg indicator shows
green means it is installed
properly, red means not.
!
The load leg has 8 positions,
the load leg indicator shows
red means the load leg is in
a wrong position.
!
Make sure the load leg is
secure by pressing down on
the front of the base.
17
25
25
26
1
-1,
-2
26
2
3. Open the lock-off and route the vehicle safety belt through
the belt path -1, and lock it into the buckle.
27
4. Tension the vehicle safety belt as much as possible while
pushing down on the base, and check it is not slack or
twisted. Close the lock-off.
!
Check the safety belt does not move by pulling and
pushing hard on base. If belt loosens or lengthens,
repeat procedure.
27
1
2
The installed base is shown as
!
Please ensure that there is
no gap between the seat
and the bottom of the base.
!
The safety belt must go
under the lock-off -1,
28
not over the lock-off.
28
-2
27
-3
27
3
28
28 1
2
-2
18