Setting The Limits; Performing Settings - testo 623 Manual De Instrucciones

Pos: 30 /TD/Produkt verw end en/testo 622/testo 622 Gr enz werte einstell en @ 4\mod_ 1254472450530_ 79.doc @ 51108 @ 2555

6.2 Setting the limits

Temperature
When changing the temperature unit from °C to °F, the set limit
values are converted
Humidity
When changing the humidity unit (%, td, wb), the set limit values
are not converted. The limit values must be reset via the Setup
menu.
Pressure
It is not possible to set the limit values.
Pos: 31 /TD/Produkt verw end en/testo 622/testo 622 -Ei nstellungen vor nehmen @ 3\mod_1234168105590_ 79.doc @ 23845 @ 2
3.

6.3 Performing settings

1. Press and hold
> Display flashes.
2. Select the required function with [Set].
> The adjustable parameter flashes.
3 Set values with
settings, see following table).
- Instrument changes to the next display function
- Instrument changes to the next display function
[Set] for 2 s.
[ ]or

To scroll rapidly forward and back in the relevant menu,
[
press and hold

[Esc]
Press to cancel settings without saving them.
Hold [Set] down for 2 s to save previously set values and
leave the menu.
If the entire Setup menu is run through, the settings made
are automatically stored.
If no key is pressed within 30 s, the screen reverts to the
current reading display automatically. No settings are
saved.
[ ]
and confirm entry with

].

or
6 Using the product
[Set]
(for
31