Maintenance And Service - Garland FUM 250 MG Manual De Instrucciones

English
2. Open the water tap of the lance
3. You can also regulate the pulverizing pressure by
turning the pressure regulator.
4. Begin spraying the product in the desired area.
While working, always hold the spraying hose with one
or two hands.
7.3. COMPLETION OF SPRAYING
Once you stop using the machine:
- Turn off the machine and leave it on the ground.
- Empty the fumigation tank and clean it.
- If you have used a liquid product fill the tank with
water, start the machine again and
fumigate only with water for one minute to ensure
that all the pipes are clean.

8. MAINTENANCE AND SERVICE

Perform periodic inspections on the machine to
ensure efficient operation of the machine. For a
complete maintenance we recommend that you take
the machine to your technical service.
Before performing any maintenance on the
machine or repair make sure that the engine
is stopped and remove the spark plug pipe.
Carry out all maintenance on the machine
with it on a flat and clear surface.
Utilice sólo recambio adecuado para ésta máquina
con el fin de obtener un rendimiento adecuado de la
máquina. Éste recambio lo puede encontrar en los
distribuidores oficiales de la máquina. El uso de otro
recambios puede provocar riesgos, daños al usuario, a
la gente de alrededor y a la máquina.
Don't adjust the carburetor. If necessary, take your
machine to the technical service. The adjustment of
the carburetor is complicated and only the technical
service should do it. Incorrect adjustment of the
carburetor can cause damage to the engine and will
be grounds for voiding the warranty.
Always adjust the machine on a flat and stable
surface.
The removal of safety devices, improper maintenance,
replacement of items with non-original spare parts
can cause bodily injury.
A general visual check is recommended every 3
months to check the condition of the machine, to
check for leaks, loose parts and check the condition
of the connections. In this way its lasting operation is
ensured. If you find an anomaly, repair it or take your
equipment to the technical service.
38/120