Publicidad
Idiomas disponibles
Idiomas disponibles
4.1.1.-
To consider.
• It is a must to comply with the «Safety instructions», being the user the responsible of its observance. Read them
carefully and follow the stated steps in the stablished order.
site, may invalidate some recommendations contained in this manual. Where discrepancies exist, the user must
comply the pertinent local standards.
The instructions and drawings of this manual are generic for the complete series and they are mere reference. If your
model doesn't have any of the described parts, omit all reference to them and continue. On the other hand the equipment
is supplied completely tagged by means of serigraphy or labelling, pay attention at the same one.
• For long shutdown periods, the equipment must be connected every four months for 6 hours as minimum to mains, in
order to recharge the batteries, and to avoid as much as possible the irreversible degradation of them. On the other hand,
in case of unit storing, it must be placed in a cool and dry place, never outdoor.
• Do not install the equipment in corrosive, dusty environments and never outdoor. Avoid direct sunlight.
• The location must be cooled, far from heat sources and with easy access. Leave a minimum space of 25 cm. around
the equipment for the circulation of the cooling air.
Do not obstruct the cooling grids or insert objects through them or other wholes.
• Do not place materials on the equipment or elements that might prevent the front from being seen.
• Fit the unit as close as possible to the electrical mains outlet and to the loads to be supplied.
• Do not clean the unit with abrasive, corrosive, liquids or detergents products. If you wish to clean the unit, pass a
damp cloth and dry immediately. Avoid splashing or spilling, which might enter into the slots or cooling grids.
• In order to prevent the batteries from a complete discharge and as a safety measure after a long mains fault and at the
end of the working day, the loads must be shut down, followed by the shutdown of the unit too, according to the
operation described in the «User's manual».
• When a magnetothermic has to be replaced, the replacement will have the same size and type.
Installing the UPS is as easy as following the steps shown. Be aware of the Power Switch must be kept in the
«ON» position, otherwise, the UPS will be disabled and your equipment will not be protected during a power
failure.
4.1.2.-
General warnings.
• The SPS is a continuous supply unit. If there is a mains fault when it is running, the output lines still have voltage,
depending on the back up time given by the battery set.
• All connections will be made without electrical mains present and with the unit on rest.
• The cable cross sections used to feed the unit and the loads to be supplied will be in harmony with the nominal current
stated on the nameplate adhered to the unit, by respecting the Low Voltage Electro-technical standards.
• Pay special attention to the labelling of the equipment that warns of «Danger of electrical discharge « and indicated
as (
). There are hazardous voltages inside the unit: never open the case, the access must only be made by
authorised and competent personnel. In the event of maintenance or failure, consult your closest S S S S S .T .T .T .T .T.S .S .S .S .S. . . . .
The local regulations and different restrictions at client's
- 36 -
Publicidad
