Tuning Into A Preset Station; Other Convenient Tuner Functions - JVC KD-S7250 Manual De Instrucciones

Manual preset
You can preset up to 6 stations in each band (FM1,
FM2, FM3 and AM) manually.
Ex: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the band (FM1 – 3, AM) you
want to store FM stations into (in
this example, FM1).
• Each time you press the button, the FM
band changes as follows:
FM1
AM
2
Tune into a station of 88.3 MHz.
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
10
FM2 FM3
Press ¢
to tune in
stations of higher
frequencies.
Press 4
to tune in
stations of lower
frequencies.
"P1" flashes for a few
seconds.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.

Tuning into a preset station

You can easily tune into a preset station.
Remember that you must store stations first. If you
have not stored them yet, see "Storing stations in
memory" on page 9 and 10.
1
Select the band (FM1 – 3, AM).
FM1
AM
2
Select the number (1 – 6) for the preset
station you want.
Other convenient tuner
functions
Scanning broadcast stations
When you press RPT SCAN while listening to the
radio, station scanning starts. Each time a
broadcast is tuned in, scanning stops for about 5
seconds (tuned frequency number flashes on the
display), and you can check what program is now
being broadcasted.
If you want to listen to that program, press the same
button again to stop scanning.
FM2 FM3