Hitachi C 8FSHE Manual De Instrucciones página 23

Ocultar thumbs Ver también para C 8FSHE:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

(2) Setting to cut crown moldings at positions 2 and 3 in Fig. 34 (see Fig. 37; tilt the head to the left):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the lower surface (B in Fig. 33) contacts the fence as in Fig. 39.
1
Miter angle scale
Fence
A
Cutting method of crown molding without tilting the saw blade.
Crown molding Vise Ass'y
Crown molding Stopper (R)
(optional accessories)
(optional accessories)
6mm Knob
Bolt
6mm Knob Bolt
Crown molding Stopper (L)
6mm Wing Bolt
(optional accessories)
Fig. 40-a
Crown molding vise ass'y
(Optional accessories)
6mm knob bolt
Fence
6mm wing bolt
Crown molding
Fig. 40-b
WARNING:
Always firmly clamp or vise to secure the crown molding to the fence; otherwise the
crown molding might be thrust from the table and cause bodily harm.
Do not bevel cutting. The main body or saw blade may contact the sub fence, resulting
in an injury.
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
Head
Bevel angle scale
Fence
4
Base
Turntable
Fig. 36
B
Table on Base
Fig. 38
(1) Crown molding Stopper (L) and (R) (optional accessories) allow
easier cuts of crown molding without tilting the saw blade.
Install them in the base both-sides side to be shown in Fig. 40-
a. After inserting Tighten the 6mm knob bolts to secure the
crown molding Stoppers.
[Optional accessories used]
• Crown molding Vise Ass'y (Include Crown molding Stopper
(L))
• Crown molding Stopper (L)
• Crown molding Stopper (R)
(2) The crown molding vise (B) (Optional accessory) can be
mounted on either the left fence (Fence (B)) or the right fence
(Fence (A)). It can unite with the slope of the crown molding
and vice can be pressed down.
Then turn the upper knob, as necessary, to securely attach the
Knob
crown molding in position. To raise or lower the vise assembly,
first loosen the 6mm knob bolt.
After adjusting the height, firmly tighten the 6mm wing bolt;
then turn the upper knob, as necessary, to securely attach the
the crown molding in position. (see Fig. 40-b)
Crown molding stopper (L)
Crown molding stopper (R)
(Optional accessories)
Head
Bevel angle scale
3
2
Fence
Base
Miter angle scale
Turntable
Fig. 37
Fence
A
B
Table on Base
Fig. 39
English
23

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

C 8fse

Tabla de contenido