Compressed Air Hook-Up; Safety Regulations - Corghi ProLine 640 Manual De Uso

trical board and without the use of a plug,
install a key-operated switch or suitable
lock-out device to restrict machine use
exclusively to qualified personnel.
WARNING
For the correct functioning of the machine
it is vital to have a good ground connection.
NEVER connect the machine ground wire
to a gas pipe, water pipe, telephone cable
or any other unsuitable object.
COMPRESSED AIR
HOOK-UP
WARNING
The compressed air hook-up may only
be performed if the pneumatic ring nut
is supplied (optional accessory supplied
on request).
WARNING
All compressed air hook-ups must be car-
ried out by qualified personnel only.
- The hook-up to the workshop compressed
air system must ensure a minimum pres-
sure of 8 bar.
- A universal union is used for connection to
the compressed air system. No special or
additional adaptor is needed for connec-
tion. A pressure-resistant hose with 6mm
inner diameter and 14mm outer diameter
must be fastened to the notched union
using the clamp provided with the ma-
chine.
SAFETY
REGULATIONS
WARNING
Failure to comply with the instructions and
danger warnings can cause serious injuries
to the operator or other persons.
User manual ProLine 640
Do not operate the machine until you have
read and understood all the danger/warning
notices in this manual.
In order to operate the machine correctly, it
is necessary to be a qualified and authorised
operator, able to be trained and to know the
safety regulations. Operators are expressly
forbidden from using the machine under
the influence of alcohol or drugs capable of
affecting physical and mental capacity.
The following conditions are essential:
- read and understand the information and
instructions described in this manual;
- have a thorough knowledge of the features
and characteristics of the machine;
- keep unauthorised persons well clear of
the working area;
- make sure that the machine has been
installed in compliance with all relevant
standards and regulations in force;
- make sure that all machine operators are
suitably trained, that they are capable of
using the machine correctly and safely and
that they are adequately supervised during
work;
- do not touch power lines or the inside of
electric motors or other electrical equip-
ment before making sure that they have
been powered off;
- read this booklet carefully and learn how
to use the machine correctly and safely;
- always keep this user manual in a place
where it can be readily consulted and do
not fail to refer to it.
WARNING
Do not remove or deface the DANGER,
WARNING, CAUTION or INSTRUCTION de-
cals. Replace any missing or illegible decals.
If one or more decals have been detached
or damaged, they can be replaced by your
nearest manufacturer dealer.
- When using and carrying out maintenance
on the machine, observe the unified in-
dustrial accident prevention regulations
for high voltage industrial equipment and
UK
43