Changing Needle; To Remove And Attach The Foot Holder; To Remove; To Attach - Sears Kenmore 385.16231 Manual De Instrucciones

Changing Needle
(_ Needle clampscrew
(_)Needle clamp
[_Turn offthepower s witch..
Raise theneedle to itshighest position byturning the
handwheel counterclockwise, toward you,andlowering
thepresser f oot Loosen theneedle clamp screw(_by
turning itcounterclockwise. Remove t heneedle fromthe
needle clamp _,
[] Insert a newneedle intotheneedle clamp(_with the
flatsidetothe rear.Wheninserting theneedle intothe
needle clamp (_, pushit upasfarasit goes. T ighten
theneedle clamp screw (_ firmlybyturning it clockwise,
[_To seeiftheneedle is good, p lace theflatsideofthe
needle ontosomething f lat(needle plate, g lass, e tc.),
Thegapbetween theneedle andtheflatsurface should
beconsistent,. Never u sea bent o r bluntneedle.
A damaged n eedle cancausepermanent snags or runs
in knits,finesilksandsilk-like fabrics.
To Remove
and Attach the Foot Holder
(_ Thumb screw
(_) Foot holder
(_ Presser bar
• To remove
Remove the thumb screw(_by turning it counterclockwise
with a screwdriver,
o To attach
Match the hole in the foot holder (_)with the threaded
hole in the presser bar (_ Fit the thumb screw(_into
the hole,. Tighten the screw(_by turning it clockwise with
a screwdriver,
Changing
Presser Foot
(_) Snap-on button (red button)
(_) Groove
(_ Pin
o To remove
Raise the needle to its highest position by turning the
handwheel counterclockwise. Raise the presser foot, and
press the red button (_on the back of the foot holder,
• To attach
Place the selected presser foot, so that the pin(_) on the
foot lies just under the groove(_)on the foot holder, Lower
the presser bar to lock the foot into place.
[]
f
%,,¸¸
f
Flat side
Lade piano ....._
Meplal vers r_
[]
Needle
Aguja
Aiguilte
[]
,J
.$
12