Section Ii. Getting Readyto Sew; Connecting Machine To Power Supply; Before Using Your Sewing Machine; For Your Safety - Sears Kenmore 385.16231 Manual De Instrucciones

SECTION li. GETTING READY TO SEW
Connecting Machine to Power Supply
(_ Foot control plug
(_) Machine plug
(_ Power supply plug
(4_ Power switch
Power supply cord
(_) Foot control
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power
1. Turn off the power switch ¢_.
2. Insert the foot control plug (_, machine plug _ into the
machine.
3 Insert the power supply ptug (_ into the outlet
4 Turn the power switch.
Before Using Your Sewing Machine
Before using your sewing machine for the first time, place a
waste fabric under the presser foot and run the machine
with thread for a few minutes. Wipe away any oil which may
appear
For Your Safety
* While in operation, always keep your eyes on the sewing
area Do not touch any moving parts such as the thread
take-up lever, handwheel or needle..
* Always turn off the power switch and unplug from the
power supply:
- When leaving the machine unattended.
- When attaching or removing any parts
- When cleaning the machine..
* Do not place anything on the foot control, when not
sewing..
Polarized plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If the plug
does not fit in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet..
Do not modify the plug in any way.
Foot Controller Model 21316 or YC-485 is used with
Sewing Machine Model 385.16231XXX (XXX represents
numbers 000 through 999)..
Controlling Sewing Speed
Sewing speed is varied by the foot control.=
The harder you press on the foot control, the faster the
machine runs.
®
®
%
®
..................... J
.... J
6