Angelo Po FX 61 E3 Manual De Uso página 118

Connect the appliance to the mains electricity supply
as follows.
1 – If not already present, install an automatic circuit-
breaker (B), close to the appliance, with the following
characteristics.
– Thermal breaker device (to adjust see table on
page 4).
– Differential breaker set at 30 mA
– Class B or C (IEC 898)
2 – Undo the screws and remove the side panel (A).
3 – Connect the automatic circuit-breaker (B) to the
appliance's terminal board (C) and to the electrical
mains supply, in accordance with the electrical sys-
tem diagram provided at the back of the manual and
using a cable with the following characteristics.

– Weight:
than H05RN-F type (designation 245 IEC
57)
– Temperature of use:
Important
When connecting, take care to connect the neu-
tral and earth lines.
4 – Replace the panel and retighten the screws when the operation is complete.
CONVERSION OF ELECTRICITY SUPPLY
To carry out this operation, proceed as follows.
1 – Disconnect the mains electricity supply.
2 – Undo the screws to remove the side panel (A).
3 – Fit the jumper (B) to make the electrical connec-
tion of the terminals (C-D) (see attached wiring dia-
grams).
IT
4 – Remove the carter (G) and change the connec-
tions to the heating element terminals (H) as shown in figure.
GB
DE
400 V
FR
ES
H
English

70°C.
230 V
H
C
B C D
- 56 -
B
A
IDM-39617701600.tif
A
IDM-39617701700.tif
G
IDM-39617701900.tif
Use and installation manual