Using The Microcular; Care And Maintenance - Bresser National Geographic 90-39100 Instrucciones De Uso

TIP:
To use the MicrOcular long-term we recommend to
i
always connect it to the same USB port.

10. Using the MicrOcular

10.1. Preparation
1. Slide a specimen under your microscope and focus on it.
2. Remove the eyepiece and Barlow lens from the eyepiece support and the dust
cap from your MicrOcular and install same in the eyepiece supports instead of
the Barlow lens.
3. Start your PC if you haven't yet and connect your MicrOcular to the USB port of
your computer.
10.2. Showing and saving MicrOcular images on your PC
1. Start the Photomizer Software.
2. Click „Open camera"
3. In the event that you have connected more than one unit, you can choose the
desired unit in the subsequent selection. Click on "USB 2.0 Webcam". If only
one device is connected, this step is omitted.
4. The camera image should now be visible on your screen. Focus the microscope
image.
5. Click „Capture" to record an image. It will then be shown on the right.
6. Click on it to select it and then click „Transfer image".
7. This takes you to the Photomizer software.
8. File - Save as
18
10.3. The Photomizer Software
If you need help in the „Photomizer" programme click „?" and then „Open help". If
you need further assistance please visit the maker's home page at www.photomizer.
net/bresser

Care and maintenance

Before cleaning, separate the device from the power supply by removing the plug.
Only use a dry cloth to clean the exterior of the device.
NOTE:
Do not use any cleaning fl uid to avoid damaging the electronics.
Clean the lenses eyepieces and lenses only with a soft, lint-free cloth, like a mi-
crofi bre cloth.
NOTE:
Do not apply excess pressure to the cloth so as to avoid scrat-
ching the lenses.
To remove more stubborn dirt, moisten the cleaning cloth with an eyeglass-clean-
ing solution and wipe the lenses gently. Protect the device from dust and moisture.
After use, particularly in high humidity, let the device acclimatize for a short period
of time, so that the residual moisture can dissipate before storing.
Troubleshooting
Problem Solution
No picture visible • switch light on
• adjust focus
Picture fl ickers • if necessary,
while viewing adjust resolution of the
with PC eyepiece video graphics board