Metabo HPT C 10FSHC Manual De Instrucciones página 17

(2) Left and right bevel angle cutting
Adjust the table insert in the manner shown in Fig. 10-b and Fig. 10-c following the
same procedure for right angle cutting.
CAUTION:
2. Use of sub fence (A)
WARNING:
Sub fence (A)
Lock knob Fence (A)
Fig. 11
NOTE
: When transporting the saw, always secure the sub fence (A) in the
collapsed position and lock it.
3. Use of sub fence (B)
WARNING
Sub fence (B)
Fence (B)
Lock knob
Fig. 12
After adjusting the table insert for right angle cutting, the table
insert will be cut to some extent if it is used for bevel angle cutting.
When bevel cutting operation is required, adjust the table insert
for bevel angle cutting.
The sub fence (A) must be extended when making any right angle
bevel cut. Failure to extend the sub fence (A) will not allow enough
space for the blade to pass through which could result in serious
injury. At extreme miter or bevel angles the saw blade may also
contact the fence.
This power tool is equipped with a sub fence (A).
In the case of direct angle cutting and left bevel angle cutting,
use the sub fence (A). Then, you can realize stable cutting of the
material with a wide back face.
When right angle cutting, loosen the lock knob, then slide the
sub fence (A) outward, as shown in Fig. 11.
When you slide sub fence (A) outward, if enough space cannot
be secured or the sub fence (A) comes into contact with other
parts of the tool including the motor, fully remove sub fence (A)
from fence (A). Also, make sure to remove the lock knob from
fence (A).
: The sub fence (B) must be extended when making any left angle
bevel cut. Failure to extend the sub fence (B) will not allow enough
space for the blade to pass through which could result in serious
injury. At extreme miter or bevel angles the saw blade may also
contact the fence.
This power tool is equipped with a sub fence (B). In the case of
direct angle cutting and right bevel angle cutting, use the sub
fence (B). Then, you can realize stable cutting of the material with
a wide back face. When left angle cutting, loosen the lock knob,
then slide the sub fence (B) outward, as shown in Fig. 12.
When you slide sub fence (B) outward, if enough space cannot be
secured or the sub fence (B) comes into contact with other parts
of the tool including the lower guard, fully remove sub fence (B)
from fence (B).
English
17