Metabo HPT C 10FSHC Manual De Instrucciones página 33

(3) Setting to cut crown moldings at positions 1 and 4 in Fig. 32 (see Fig. 37; tilt the head to
the right):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the upper surface (Ⓑ in Fig. 31) contacts the fence
as indicated Fig. 39.
(4) Setting to cut crown moldings at positions 2 and 3 in Fig. 32 (see Fig. 38; tilt the head to
the right):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the lower surface (Ⓐ in Fig. 31) contacts the fence
as in Fig. 40.
Bevel angle scale
4
Miter angle scale
Turntable
Fence
Ⓑ
WARNING:
Head
Fence (A)
1
Base
Fig. 37
Ⓐ
Table on base
Fig. 39
Always fi rmly clamp or vise to secure the crown molding to the
fence; otherwise the crown molding might be thrust from the
table and cause bodily harm.
35.3°
31.6°
30°
33.9°
35.3°
31.6°
30°
33.9°
Bevel angle scale
Fence (B)
3
Base
Fence
Ⓐ
English
Head
2
Miter angle scale
Turntable
Fig. 38
Ⓑ
Table on base
Fig. 40
33