Selecting A Speed Setting; Starting And Ending The Treatment; Treatment Steps - Silk’n Bright Manual Del Usuario

6.4 Selecting a speed setting

1. Select an operation mode (see chapter "Switching on/off and
selecting an operation mode").
2. Press the increase button ( )
in the selected operation mode to select a speed setting (1–7).
The default level is 4.

6.5 Starting and ending the treatment

• You may start your treatment after selecting an operation
mode and a speed setting.
• Once the facial brush starts, you will hear a beep sound every
30 seconds, hinting you about the time that has passed. The
facial brush will automatically switch off after 2 minutes. Please
note that whenever you change the operation mode or speed
setting during treatment, the timer will be reset to zero.
• You can also end the treatment anytime by pressing the
control button ( )
current operation mode.

7. Treatment steps

1. Make sure the facial brush has enough battery power before
use (see chapter "Charging").
2. Dampen your face and the facial brush with lukewarm water.
Apply your regular face wash product on the face (see step 1
in Fig. B).
3. Turn on the facial brush, select the vibrating mode and a speed
setting (see chapter "Operation").
4. Cleanse the face by moving the cleansing area (
the face in circular movements. Use the area with thicker studs
for areas that need precise cleansing (e.g. around the nose, eyes
and chin) and use the area with thinner studs for the larger
areas (e.g. forehead, cheeks and neck) (see step 2 in Fig. B). The
facial brush will automatically switch off after 2 minutes.
5. Thoroughly rinse the face and facial brush with water and then
wipe them dry with a clean, dry towel (see step 3 in Fig. B).
6. Apply your serum or day/night cream on the face.
7. Turn on the facial brush and select the pulsating mode and a
speed setting (see chapter "Operation").
or decrease button ( )
4
once or twice, depending on the
5
6
or ) over
1 2
14
EN