Transporting And Mounting; Preparing To Lift The Saw; Lifting Saw From Rear - Bosch CM10GD Instrucciones De Funcionamiento Y Seguridad

2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 30
identified below by the BULLET (•) symbol.
• Unplug electric cord and wind up. Use the
hook and loop strap to hold the wrapped
cord together.
• Never lift the saw by gripping any of the
mechanism parts. The saw may move and
cause severe injuries to your fingers or
hands.
• To avoid back injury, hold the tool close to
your body when lifting. Bend your knees so
you can lift with your legs, not your back.
Lifting the saw from the back is the
preferred method. This will tip the tool
toward your body.
• Never lift tool by holding switch handle.
This may cause serious damage.
• Never lift the miter saw by the power cord
or the operational handle. Attempting to
lift or carry the tool by the power cord will
damage the insulation and the wire
connections, resulting in electric shock or
fire.
• Place the saw on a firm, level surface
where there is plenty of room for handling
and properly supporting the workpiece.
• ONLY lift this saw by the cast-in carry
handles at each side of the bottom of the
base (see Figure 27).
Cast-In
Carry
Handle
Bevel Lock Lever

Transporting and Mounting

To avoid injury, follow
all statements
Head
Assembly
Lock Pin
Cast-In
Carry
Handle
Miter Lock Knob
Figure 27

▼ PREPARING TO LIFT THE SAW

1. Set bevel angle at 0° and lock in place using
the bevel lock lever.
2. Rotate the table to either 45° or 0° and lock
into place using the miter lock knob.
3. Lock the saw head in the DOWN position
with the head assembly lock pin.
4. Slide the head assembly completely to the
front and engage the slide rail lock knob by
tightening the knob to the right (clockwise)
(figure 27).
5. Check that each sliding base extension is in
the closed and locked position, (figure 27).

▼ LIFTING SAW FROM REAR

1. Set bevel angle at 0° and lock in place using
the bevel lock lever.
2. Rotate table to the extreme left position
and lock in place using miter lock knob.
3. Push saw head back and lock in DOWN
position using the head assembly lock pin.
4. Engage mechanism lock lever so the saw is
locked in the retracted position.
5. Check that each base table extension is in
the closed position and locked in place.
6. Use both hands and reach down to grip
each cast-in carry handle. Whenever
possible, lift from the back of the saw.
30