1609B06757.qxp_GCM18V-12GDC 3/25/20 12:35 PM Page 31
fied below by the BULLET (•) symbol.
•
Never lift this saw by grasping the base
extensions when they are in the ex-
tended position.
•
Unplug electric cord and wind up.
•
Never lift the saw by gripping any of
the mechanism parts.
•
To avoid back injury, hold the tool close
to your body when lifting.
•
Never lift tool by holding switch handle.
•
Never lift the miter saw by the power
cord or the operational handle. At-
tempting to lift or carry the tool by the
power cord will damage the insulation
and the wire connections, resulting in
electric shock or fire.
•
Place the saw on a firm, level surface
where there is plenty of room for han-
dling and properly supporting the
workpiece.
ONLY lift this saw by the cast-in carry han-
dles at each side of the bottom of the base
LIFTING SAW FROM REAR
12
Transporting and Mounting
To avoid possible injury, disconnect battery pack before performing any as-
sembly, adjustments or repairs.
To avoid injury, follow
all statements identi-
14
27
43
49
14
12
43
Fig. 25
49
22
27
22
49
31