Transporting, Placement & Mounting; Lifting The Saw; Mounting Applications; Mounting To Workbench - Bosch 4212L Instrucciones De Funcionamiento Y Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Transporting, Placement & Mounting
To avoid injury always observe the
WARNING
!
following:
• Unplug electric cord. Before transporting the saw,
rotate head and lock assembly to 60° right miter,
lock into detent, and lock the head assembly in the
lowered position.
Lifting Saw
• To avoid back injury, hold the tool close to your
body when lifting. Bend your knees so you can lift
with your legs, not your back.
• Lift by using the cast-in carry handles at each
side of the bottom of the base.
• Alternate lifting method: When picking tool up
from ground, use rear carrying handle and front
carrying handle (above guard).

Mounting to Workbench

Mount the saw using either the four bolt holes (5/16")
or the four nail holes to the workbench. Check for
clearance to the left and right of the saw.
1. Each of the four mounting holes should be bolted
securely using 5/16" bolts, lock washers, and hex
nuts (not included).
2. Locate and mark where the saw is to be mounted.
3. Drill four (4) 5/16" diameter holes through work-
bench.
4. Place the miter saw on the workbench aligning
holes in base with holes drilled in workbench.
Install bolts, lock washers and hex nuts. As an
alternative, you can mount the saw using drywall
screws in the four nail holes.
Supporting surface where saw is to be mounted
should be examined carefully after mounting to
ensure that no movement can occur during use. If
any tipping or walking is noted, secure the work-
bench or stand before operating the compound
miter saw.
• Never lift tool by holding main switch handle.
• Never carry the miter saw by the power cord or the
• Observe the position of the saw. People standing
• Place the saw on a firm, level surface where there
• Bolt, nail or clamp the saw to its support.
crack foot or damage base.

Mounting Applications

18.
This may cause serious damage.
operational handle. Attempting to lift or carry the
tool by the power cord will damage the insulation
and the wire connections resulting in electric shock
or fire.
behind it could be injured by thrown debris.
is plenty of room for handling and properly support-
ing the workpiece.
Be careful not to over-drive nail
CAUTION
!
or over-torque the bolt. This could
Figure: Workbench Mounting

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido