Rear Panel - Fender Princeton Reverb Manual De Instrucciones

H. IEC POWER INLET: Using the included power cord, connect to a
grounded outlet in accordance with the INPUT POWER voltage
and frequency specified at the power inlet.
I. FUSE: Provides electrical overcurrent protection.
J. POWER: Turns the amplifier on and off.
K. INTERNAL SPEAKER: Jack for internal 8-ohm speaker. If connect-
ing a different speaker to this jack, it should have an impedance of
8 ohms when this is the only jack in use.
TYPE
POWER
INPUT IMPEDANCE
OUTPUT IMPEDANCE
SPEAKER
TUBES
FUSE
ACCESSORIES
DIMENSIONS
WEIGHT
For questions and troubleshooting,
contact a Fender specialist at:
1-800-856-9801 (U.S. toll free)
1-480-596-7195 (International)
SPECIFICATIONS
PR 770
Requirements: 100 watts
1 MΩ (input 1)
8Ω (internal and external speaker jacks combined)
One 10" Jensen® P10-R (8Ω)
One pair 6V6 (power, PN 0069673300)
One 12AT7 (preamp, PN 0078799200)
F2A L 250V (100V-120V models)
Deluxe fitted cover included
Width: 20" (50.8 cm)
32 lbs. (14.5 kg)
Product specifications subject to change without notice.

REAR PANEL

L. EXTERNAL SPEAKER: Jack to allow use of multiple speakers;
wired in parallel with INTERNAL SPEAKER jack (K) and affecting
total impedance. External speaker jack does not function when
INTERNAL SPEAKER jack (K) is disconnected.
M. FOOTSWITCH: Connect the included two-button footswitch
here.
N. REVERB OUTPUT/INPUT: RCA jacks connecting output/input of
reverb pan located on the floor inside the cabinet.
Output: 12 watts RMS into 8Ω @ 5%THD, 1kHz
136 kΩ (input 2)
Three 12AX7 (preamp, PN 0074287400)
One 5AR4 (rectifier, PN 0041400000)
F1.25A L 250V (220V-240V models)
Two-button footswitch included
Height: 16.4" (41.6 cm)
2
Depth: 9.4" (23.8 cm)