Rear Panel - Fender ACB 50 Manual De Instrucciones

N. IEC POWER INLET/FUSE: Using the included power cord, con-
nect to a grounded outlet in accordance with the INPUT POWER
voltage and frequency specified at the power inlet. To check/re-
place fuse, unplug power cord and pry fuse holder from power
inlet; replace fuse only with another of the same type and rating.
O. BALANCED DIRECT OUT: Provides mic-level balanced post-
power amp output signal to external sound reinforcement and
recording equipment.
TYPE
POWER REQUIREMENTS
INPUT IMPEDANCE
OUTPUT IMPEDANCE
SPEAKER
TUBES
FUSE
DIMENSIONS/WEIGHT
For questions and troubleshooting,
contact a Fender specialist at:
1-800-856-9801 (U.S. toll free)
1-480-596-7195 (International)
SPECIFICATIONS
PR 5690
290 watts
1MΩ (input 1 of each channel)
8Ω (4Ω with external speaker)
One 15" Eminence® Special Design (8Ω)
One pair 6L6 (power: V5, V6)
F3.15AL 250V (120V model)
Width: 24.22" (61.5 cm) Height: 23" (58.4 cm)
Product specifications subject to change without notice.

REAR PANEL

P. GROUND LIFT SWITCH: Push-button switch can help eliminate
unwanted hum and buzz caused by external sources connected
to BALANCED DIRECT OUT (O).
Q. 1/4" BALANCED LINE OUT: Line-level output for post-power
amp connection to external sound reinforcement and recording
equipment.
R. EXTERNAL SPEAKER: Allows external speaker use in parallel
with internal 8-ohm speaker.
Output: 50 watts RMS into 8Ω or 4Ω @ 3%THD, 1kHz
128kΩ (input 2 of each channel)
Three 12AX7 (preamp: V1, V2, V3)
F1.6AL 250V (220V-240V models)
Depth: 14" (35.6 cm)
2
One 12AT7 (phase splitter: V4)
F4AL 250V (100V-110V models)
Weight: 55 lbs. (25 kg)