Rear Panel; Power Cord - Fender ’57 Champ Instrucciones De Funcionamiento

Vacuum Tubes
Your new Fender® amplifier comes equipped with the highest
quality tubes available, sourced from various manufacturers all
over the world. Because of occasional irregularities in supply,
the specific tube type used in each amplifier is subject to
change without notice.
When replacing output tubes, please note the specific tube
markings on the original tubes factory supplied with your
amplifier. For example, 6L6 output tube types used by Fender
include, but are not limited to: 6L6GC; 6L6WXT; 6L6C; 6L6GE;
etc. The installation of a different type may require significant
adjustment by a qualified technician to avoid reduction in
performance and tube life.
Additionally, Groove Tubes™ sorts and tests many of our
output tubes, and paints them with a color-coded label. If
your amp came supplied with, for example, White-labeled
TYPE:
PART NUMBERS:
POWER REQUIREMENT:
INPUT IMPEDANCE:
POWER AMP OUTPUT:
SPEAKERS:
TUBES:
FUSE:
DIMENSIONS:
WEIGHT:

Rear Panel

Specifications
PR 863
8160500000 (120V~, 60Hz)
8160504000 (230V~, 50Hz) UK
8160507000 (100V~, 50/60Hz) JPN
60W
1MΩ
5W into 4Ω @ < 10% THD, 1kHz
One 4Ω, 8", Weber with AlNico magnet, (P/N 0077212000)
One 5Y3GT, One 6V6GT, One 12AX7
F1.25AL, 250V (100-120V versions)
Height: 13.5 in (34.3 cm)
16.5 lb (7.5 kg)
Product specifications are subject to change without notice.
fender.com
F . POWER CORD—Connect to a grounded A/C outlet in
accordance with the voltage and frequency ratings specified on
the information label {J} of your amplifier.
G . FUSE—Protects the amplifier from electrical faults.
a blown fuse only with the type and rating specified on the
information label {J} of your amplifier.
H . SPEAKER OUTPUT—Plug-in connection for a 4Ω speaker. A 4Ω
minimum speaker load must always be connected at this jack
when the amplifier is ON to avoid damage to the amplifier.
I . VACUUM TUBES—CAUTION: Tubes get hot!
J . INFORMATION LABEL—Technical information about your
amplifier is listed here.
6L6WXT tubes, then a new set of White 6L6WXT tubes will
be the perfect direct replacement.
If you have questions or concerns, contact your Fender dealer
or authorized service center.
Model '57 Champ Amplifier
Tube locations left to right at rear:
8160501000 (110V~, 60Hz) TW
8160505000 (220V~, 50Hz) ARG
8160509000 (220V~, 60Hz) ROK
F1.0AL, 250V (220-240V versions)
Width: 12.5 in (31.8 cm)
� �
� �
� �
�� ��
��
��
�
8160503000 (240V~, 50Hz) AUS
8160506000 (230V~, 50Hz) EUR
Depth: 7.8 in (19.8 cm)
Replace
7