Preparing For Use; Switching On And Off; Setting The Cutting Angle; Setting The Cutting Depth - Parkside PHKS 1450 LASER Instrucciones De Utilización Y De Seguridad

Sierra circular de mano
Ocultar thumbs Ver también para PHKS 1450 LASER:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Preparing for use

Q
The PHKS 1450 LASER circular saw has Intelligent
Power Control.
speed range the power output remains constant when
working on harder and more resistant materials.

Switching on and off

Q
Switching on:
j
Press the safety lock­out
and keep it pressed.
j
Press the oN / oFF switch
is running you can release the safety lock­out
again.
The circular saw is fitted with an
electronic soft start system. The
motor starts with a delay.
Switching off:
j
Release the oN / oFF switch

Setting the cutting angle

Q
You can set the cutting angle accurately with the
help of the cutting angle scale.
j
Release the wing screws of the cutting angle
setting clamp
4
angle on the scale and retighten the wing
screws.

Setting the cutting depth

Q
note: If possible we recommend that the cutting
depth is set approximately 3 mm greater than the
material thickness. This should help to ensure you
achieve a clean cut.
j
Release the wing screw on the cutting depth
setting clamp
, set the required cutting depth
5
on the scale
and retighten the wing screw.
15
PHKS_1450_Content_LB5.indd 41
This automatic power
delivery system ensures
that for a particular
2
to the left or right
. once the saw
8
.
8
on both sides, set the desired

Setting the guide fence

Q
j
Release the wing screw
and insert the guide fence
Retighten the wing screw

Switching the laser on and off

Q
Switching on:
j
Move the laser oN / oFF switch
Switching off:
j
Move the laser oN / oFF switch
note: If the batteries become exhausted you should
replace them with two new ones, type AAA 1.5 V.

Working with the circular saw

Q
1. Switch on the device as described in the section
about "Switching on and off" and then place it
first with the front edge of the base plate
against the material.
2. Align the device using the guide fence
with reference to marked­out line or by using
the laser.
3. Saw with a even pressure whilst holding the
device by the handles with both hands
(see Fig. A).

Setting the speed

Q
j
Turn the wheel
to the desired speed setting
1
(arrow marking G)
(1 = lowest speed / 6 = highest speed):
Use the general settings suggested in the following
table (information offered without liability) or adjust
the speed setting on the setting wheel
material being cut.
Preparing for use
of the base plate
10
7
into the slot
.
12
11
.
10
to setting "I".
14
to setting "0".
14
7
or
12
to the
1
GB/MT
41
30.07.2008 15:15:25 Uhr

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido