Before Use; Inserting / Replacing Saw Blades; Setting The Blade Speed; Pendulum-Action Settings - Parkside PFS 710 A Instrucciones De Utilización Y De Seguridad

Sierra de calar
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Before use / Preparing for use

before use

Q

Inserting / replacing saw blades

Q
j
Wear appropriate protective gloves
when inserting and testing the blade.
j
Before replacing the blade, make sure that the
saw blade mount is free of any cutting residue
(e.g. wood splinters).
j
If necessary clean the saw
blade mount with a narrow
paintbrush or blow it out with compressed air.
1. Release the hexagonal socket head screw
using the Allen key
2. Insert the saw blade between the plunger
and the clamping plate
Make sure that the locating pin
the locating hole of the saw blade.
3. Retighten the hexagonal socket head screw
Check before you use the saw that the saw
blade is safely and firmly seated.

Setting the blade speed

Q
The desired blade oscillation speed can be prese-
lected by using the setting wheel
oscillation speed, MAX. = highest oscillation speed).
The blade speed can also be selected whilst you
are using the device.

Pendulum-action settings

Q
You can set the pendulum action using the pendulum-
action rotary switch
4
28 GB/MT
.
5
.
11
engages in
10
(MIN. = lowest
1
to adjust the effectiveness
of the sawing action of the blade to suit the material
to be cut.
Setting 0 (pendulum action is switched off):
This setting is suitable for sawing thin or hard mate-
rials. This setting can also be used to produce
clean-cut edges.
Setting I:
Suitable for materials of medium strength, e.g.
hardwood, plastic.
Setting II:
Use this setting when you are sawing soft materials
such as lightweight building or insulation materials.
6
Setting III:
Set the rotary switch in this position if you are cutting
9
softwood / pruning trees or soft materials.

Preparing for use

Q
.
6
The voltage at the mains socket must match that
shown on the rating plate on the device. Devices
marked with 230 V ~ can also be operated at
220 V ~ .

Switching on and off

Q
When operating the device you can select between
intermittent or continuous operation mode.
to switch on intermittent operation mode:
j
Press the On / Off switch
to switch off intermittent operation mode:
j
Release the On / Off switch
to switch on continuous operation mode:
j
Press the On / Off switch
pressed position with the lock button
to switch off continuous operation mode:
j
Press the On / Off switch
.
3
.
3
and fix it in the
3
.
2
and release it again.
3

Publicidad

Tabla de contenido
loading

Tabla de contenido