Recording An Audio Source - Aiwa AV-DV70 Manual De Instrucciones

TO PLAY A DVD OR LD RECORDED IN
DOLBY DIGITAL SURROUND
This receiver is equipped with the Dolby Digital decoder and
has the DIGITAL IN (both OPTICAL and COAXIAL) terminals.
When a DVD or LD player is connected to the DIGITAL IN terminal
of the receiver, you can enjoy theater-quality audio right in your
home when playing discs recorded in Dolby Digital Surround.
Before operation
Check that the TAPE MONITOR is not selected. If the TAPE
MONITOR is selected, press the TAPE MONITOR button so that
"TAPE OFF appears on the display.
1
2
Press the VIDEO 1 (VIDEO 2) button and hold it
down until "DIGITAL" is displayed.
The DVD (LD) player connected to the OPTICAL (COAXIAL)
DIGITAL IN terminal is selected as a source.
Start playing the DVD (LD) recorded in Dolby
Digital Surround.
The "DOLBY DIGITAL" indicator will light on the left side of
the display when the bit stream of the Dolby Digital Surround
comes in the unit.
To select the Dolby Digital Surround mode according to your
speakers, see "SELECTING DOLBY SURROUND" on page
14.
m
While the TAPE MONITOR is selected and the TAPE MONITOR
indicator turns red, "DIGITAL" cannot be selected.
When headphones are plugged in, the Dolby Digital Surround
mode is automatically changed to "2CH STEREO and the "2CH
DOWNMIX indicator lights on the display.
Even if the DOLBY SURROUND button is pressed while the
headphones are plugged in, the "DOLBY DIGITAL SUR" or"3
STEREO mode cannot be selected.
This unit supports input signals of the Dolby Digital Surround
bit stream and linear PCM whose sampling frequency is 32
kHz, 44.1 kHz and 48 kHz. The unit cannot play the DVDS
whose sampling frequency is 96 kHz.
RECORDING AN AUDIO SOURCE
1
2
3
TAPE MONITOR
1
Select the program source to be recorded.
Press one of the function buttons.
Set the tape deck or MD recorder to the recording
mode.
Start the selected program source.
To monitor recorded sound during recording
(when the
connected tape
deck is a three-head system)
Press the TAPE MONITOR button. "TAPE ON" appears on the
display for four seconds, and then the source name selected in
step 1 comes back on. To cancel the tape monitor, press it again
so that "TAPE OFF appears.
Any sound control system has no effect on recording (see page
8).
Input sound through the DIGITAL IN terminals cannot be
recorded. When recording the sound from the DVD or LD player,
connect the analog AUDIO OUT terminals of the player to the
corresponding AUDIO IN terminals of the receiver.
The sound will be recorded in 2 ch stereo.
When recording sources by the MD recorder connected to the
VIDEO l/DVD/MD AUDIO OUT terminals, select the source
after pressing the VIDEO 2 or VIDEO 3 button (V2 or V3 should
be displayed).
Recording cannot be done while the VI indication is displayed
on the window.
Input sound from the tape deck connected to the TAPE
MONITOR IN terminals cannot be recorded.
11
ENGLISH