Operating Elements And Connections; Safety Notes - Monacor security AV-600BS Manual De Instrucciones

Please unfold page 3. Then you can always see the
operating elements and connections described.

1 Operating Elements and Connections

1 POWER switch
2 POWER LED
3 LED WIRE: lights up if the unit has been switched
to the reproduction of the signals at the inputs
VIDEO IN (7) and AUDIO IN (8) with the button
WIRE/WIRELESS (17)
4 Channel LED WIRELESS CH.
1 x short flashing = channel 1
2 x short flashing = channel 2
3 x short flashing = channel 3
4 x short flashing = channel 4
5 Channel selector switch SELECT for manual
switching between the receiving channels 1 to 4
6 Battery compartment cover
7 Jack VIDEO IN for connection to the video output
of a cable-connected camera or a video recorder
8 Jack AUDIO IN for connection to the audio output
of a cable-connected camera or a video recorder
9 Jack VIDEO OUT for connection to the video input
of a second monitor or a video recorder
10 Jack AUDIO OUT for connection to the audio input
of a second monitor or a video recorder
11 Power supply jack DC 13.5V IN for connection of
the supplied power supply unit
12 Button AUTO SCAN for switching the automatic
channel switching on and off
13 Control V-HOLD for the picture synchronization
14 Control BRIGHT
15 Control CONTRAST
16 Control VOLUME
17 Selector switch WIRE/WIRELESS
Button pressed: The signals of the jacks VIDEO IN
(7) and AUDIO IN (8) are re-
produced
not pressed: The monitor is switched to wire-
less reception

2 Safety Notes

The units (monitor and power supply unit) correspond
to the directive for electromagnetic compatibility
89/336/EEC. The power supply unit additionally cor-
responds to the low voltage directive 73/23/EEC.
Attention!
The power supply unit and the monitor are supplied
with very high voltage dangerous to life. Leave servic-
ing to skilled personnel only. Inexpert handling may
cause an electric shock hazard. Furthermore, any
guarantee claim will expire if the monitor or the power
supply unit has been opened.
Please observe the following items in any case:
Caution! The picture tube is vacuous. In case of
mechanical damage, there is an implosion hazard
and scattered glass may cause injuries.
The monitor and the power supply unit are suitable
for indoor use only. Protect them against dripping
water and splash water, high air humidity, and ex-
treme temperatures (admissible ambient temperatu-
re range -10 °C to +55 °C).
Do not place any vessels filled with liquid, e. g. drink-
ing glasses, on the units.
The heat being generated in the monitor must be
carried off by via air circulation. Therefore, never
cover the air vents at the housing. Do not insert any-
thing or do not let anything fall into the air vents! This
could result in an electric shock.
Do not set the monitor into operation, and imme-
diately disconnect the power supply unit from the
mains socket if
1. there is visible damage to the monitor or to the
power supply unit,
2. a defect might have occurred after a drop or simi-
lar accident,
3. malfunctions occur.
The units must in any case be repaired by skilled
personnel.
For cleaning only use a dry, soft cloth, by no means
chemicals or water.
No guarantee claims for the units and no liability for
any resulting personal damage or material damage
will be accepted if the units are used for other pur-
poses than originally intended, if they are not cor-
rectly connected or operated, or not repaired in an
expert way.
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful to
the environment.
Do not put exhausted batteries into the
household rubbish but only take them to a
special waste disposal (e. g. collective con-
tainer at your electrical supply shop).
GB
7