Packet Data Connection - Nokia 6282 Manual Del Usuario

S e t t i n g s
If data transfer is not started within 2 minutes after the activation of
the IR port, the connection is canceled and must be started again.
IR connection indicator
When is shown continuously, the IR connection is activated, and
your phone is ready to send or receive data through its IR port.
When blinks, your phone is trying to connect to the other device, or
a connection has been lost.
Packet data
WCDMA and general packet radio service (GPRS) are network services
that allow mobile phones to send and receive data over an Internet
protocol (IP)-based network. WCDMA and GPRS are data bearers that
enable wireless access to data networks such as the Internet.
Enhanced GPRS (EGPRS) is similar to GPRS but enables faster connections.
For more information on availability of EGPRS and data transfer speed,
contact your network operator or service provider.
The applications that may use WCDMA or (E)GPRS are MMS, video
streaming, browsing sessions, e-mail, remote SyncML, Java application
downloading, and the PC dial-up.
When you have selected GPRS as a data bearer, the phone uses EGPRS
instead of GPRS if this is available in the network. You cannot select
between EGPRS and GPRS, but for some applications you may be able
to select GPRS or GSM data (circuit switched data, CSD).

Packet data connection

Select Menu > Settings > Connectivity > Packet data > Packet data
connection, and from the following options:
Always online—to set the phone to automatically register to a packet
data network when you switch on the phone. or indicates that
the packet data service is available.
If you receive a call or a text message, or make a call during a packet
data connection, or indicates that the packet data connection
is suspended (on hold).
66