El I M I N A T I N G B L O C K A G E S; C L E A N I N G - BDS Maschinen MAB 150 Instrucciones De Manejo

C l e a n i n g

El i m i n a t i n g b l o c k a g e s

W A R NING
D a n g e r o f c u t i n j u r i e s f r o m
t o o l p a r t s o r s w a r f .
► Put protective gloves on before
starting work.
B l o c k a g e s c a u s e d b y a b r o k e n t o o l :
Switch off the machine with the red
‹
button (12) of the motor switch.
Hold the handle tightly (5) to stop the
‹
machine from slipping.
Switch off the magnetic clamp with the
‹
switch (10). The indicator lamp in the
switch (10) extinguishes.
Disconnect the voltage supply (pull out
‹
the mains plug).
Use the hand lever (6) to move the
‹
machine slide to the upper position.
Replace defective tool. Remove swarf.
‹
O t h e r b l o c k a g e s :
Switch off the machine with the red
‹
button (12) of the motor switch. Leave
the magnetic clamp switched on.
Use the hand lever (6) to move the
‹
machine slide to the upper position.
Remove swarf and check tool.
‹
1 8
b r o k e n ►
►
CAUTION
►
‹
‹
‹
‹
‹
C l e a n i n g
W A R NING
Switch off the machine and
disconnect the voltage supply before
performing maintenance or cleaning
(pull out the mains plug).
When using compressed air for
cleaning, wear protective goggles and
gloves and protect other persons in
the working area.
Never immerse the machine in water
or other liquids.
A f t e r e v e r y u s e
Remove the inserted tool.
Remove swarf and coolant residues.
Clean the tool and the tool holder on
the machine.
Clean the guide of the machine slide.
Put the machine and accessories into
the transport case.
M A B 1 5 0