BDS Maschinen MAB 150 Instrucciones De Manejo página 9

W A R NING
► When working on scaffolding, the
operator must be secured with a
safety belt as the machine can
oscillate dangerously in the event of
interruption to the power supply.
► Check for secure clamping of the
electromagnets on the substrate
before every use (see section
Preparing).
► Secure the machine with the safety
chain (D) supplied when working in
an inclined or vertical position and
during overhead work. The machine
could fall down if the magnet is
loosened or the power fails.
► Check that the tool is tightened
securely before using (see section
Inserting the tool).
► Do not allow the connecting cable to
hang over edges (trip wire effect).
M A B 1 5 0
P r e v e n t i n g d a m a g e
CAUTION
P o t e n t i a l d a m a g e t o p r o p e r t y i f t h e
m a c h i n e i s i m p r o p e r l y u s e d !
Observe the following instructions to
avoid property to damage:
► Before connecting the machine,
compare the connection data (voltage
and frequency) on the rating plate
with those of your mains power
supply. The data must correspond
in order to avoid damage to the
machine.
► Always carry the machine by the
handle.
► Do not pull the mains cable to remove
the plug from the mains socket.
► Do not crush the connecting cable.
► Do not expose the connecting cables
to heat or chemical liquids.
► Do not pull the connecting cable
across sharp edges or hot surfaces.
► Lay the connecting cable so that it
cannot be caught and wound up in
the rotating parts of the machine.
Sa f e t y
1 1