Pioneer SX-S30DAB Manual De Instrucciones página 34

> Before Start > Part Names
TV "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
TV input selector. (Default Value is "-----")
> Install > Initial Setup > Playback
Speaker
You can make changes to the connection environment of the speakers and change the
volume level. Settings are automatically configured if you use Full Auto MCACC. This setting
cannot be selected if headphones are connected or audio is output from the speakers of the
TV because "Hardware" - "HDMI" - "Audio TV Out" is set to "On".
∫ Configuration
Subwoofer Set whether a subwoofer is connected or not.
"Yes (Default Value)": When subwoofer is connected
"No": When subwoofer is not connected
∫ Crossover
Front Set the low range capabilities for each channel by setting either
small or large.
"Small (Default Value)": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low range
capabilities
0 If "Configuration" - "Subwoofer" is set to "No", "Front" will be
fixed to "Large" and the low pitched range of the other
channels will be output from the front speakers. Refer to the
instruction manual of your speakers to make the setting.
Crossover When there are speakers that have been set to "Small", set the
Hz under which you would like other speakers to play bass, and
also set Hz under which you would like the LFE (low frequency
effect) to play the bass.
0 The value from "50Hz" to "200Hz" can be set. (Default Value
is "80Hz")
Advanced Setup | Firmware Update | Others
E
N
33