Fitting The Drawer Unit Shell To The Worktop; Completing The Assembly; Fitting The Accessories; Fitting The Rear Panel - Garant KOMPAKT Manual De Instrucciones

4.2.3

Fitting the drawer unit shell to the worktop

Take the drawers out of the
X
drawer unit shell. To do this,
DE
lift the drawers twice over
the end stop.
Turn the drawer unit shell
X
over.
If the assembly position is non-standard:
X
EN
Where necessary, mark out the non-standard holes.
„
Drill the holes.
„
Place the drawer unit
X
shell precisely over the
pre-drilled holes and screw
it on.
If necessary, fit the other
X
drawer unit shell in the
same way.
FR
IT
ES
28
4.2.4

Completing the assembly

Place the workbench on its
X
feet, using suitable lifting
gear if necessary.
Slide the drawers back in
X
again.
If necessary, fit further
X
accessories to the
workbench.
4.3.

Fitting the accessories

The following assembly is based on the example of a GARANT KOMBI
workbench.
After fitting the rear panel and the storage shelf, the screws that connect
the support legs with the worktop must then be fully tightened.
4.3.1

Fitting the rear panel

The outer faces of the support legs carry holes for securing the rear panel.
Turn the workbench over.
X
Position the rear panel on
X
the rear of the workbench
between the support legs,
and screw it on.
Tighten the screws on the
X
support legs.
www.hoffmann-group.com
DE
EN
FR
IT
ES
29